All was going well at this point, the wagons were ready to be painted. However I must remember moving small, wheeled vehicles on a painting turn table, is not a good idea; two wagons jumped ship onto the floor. Fortunately the only things damaged were the couplings. After robbing another kit for a replacement, off they went to the garage to be sprayed. (I hope Malcolm can supply some replacements)

The new wagons have been left in un weathered grey for the time being, but they look really good with the slate loads fitted.

Whilst working on the new wagons I have taken the opportunity to complete a half finished three ton wagon at the same time.

The end pillars have been fitted by bending round little tabs. The brake lever has been fitted along with the tiny bracket to hold it in place. It's a while since I did any soldering; some sore fingers- must remember how fast things get REALLY HOT! With a little cleaning up it will be ready for painting.

 The contents of one slate wagon kit...

 These kits have plain bearings so the pin points on the axles have to be filed off. I hold the wheels in a back to back gauge. Using a back to back gauge is a good idea generally as wheel sets often come with different spacings.

 The burrs are filed off the back of the wheels and then they are tested in the chassis casting.

 The wheels are captured in place by the axle box castings. When the chassis will roll across a sheet of glass every thing is glued in place. I add a dab of glue to the axles to make sure the wheels can't come loose.

 The etch for the body is removed and and tabs filed off..

 I use bending bars, metal rulers and knife blades to fold up the etch. There are some tricky folds along the bottom edge of the ends. Its rather like etched brass origami! My bending bars were obtained cheaply from ebay, and whilst not as fancy as some available, they do the job.

 The top edges are an easier fold.

 And there you have it, the wagon body. There are still end pillar wrappers to fold and fix in place.

Two finished chassis showing just how small these wagons are even in 5.5 mm scale.

 A lovely box of goodies has arrived from Malcolm Savage Models today. For anyone unfamiliar with the 5.5mm society, Malcolm is the main source of modelling materials. The slate wagon kits are quite exquisite,we  and one of the things that clinched my move from 009 to 5.5 mm scale. Malcolm produces a range of specific slate wagon models for the Ffestiniog. The ones I have received today were owned by the London and North Western Railway and have there own distinctive pattern of axle boxes. The etched bodywork produces a really intricate model which really captures the feel of these distinctive vehicles.

 Also in todays delivery, are a number of door handle etches for use with the Worsley Works carriage etches I have sitting ready to be built. Although the MSM range is small, it includes some superb detailing components.